ONE : Before the breaker is used: check
1. Is the nut of the breaker loose?
2. Whether the breaker is leaking oil, whether the hydraulic oil is sufficient, and whether the hydraulic oil is dirty.
3. Is the hydraulic hose damaged?
4. Is there any damage to the drill rod of the breaker, whether the split pin and the flat pin are in place?
5. Is the pressure of the accumulator sufficient?
6. Is the hydraulic system normal?
TWO : important matters in the work of the Excavator rock breaker
1. It is strictly forbidden to use the broken hammer drill rod to pick up things.
2, it is strictly forbidden to break the hammer
3. It is strictly prohibited to operate underwater.
4. It is strictly forbidden to use the breaker to push the object to avoid the rupture of the middle cylinder.
5. When working, the breaker drill rod should be perpendicular to the surface of the broken object as much as possible.
THREE : After the Excavator rock breaker is used (if the time is more than one week, store it as follows)
1, the breaker hose type is equipped with a plug
2. Release the nitrogen in the nitrogen chamber and push the piston of the breaker to the inside.
3. Remove the breaker hammer rod
4, the breaker is stored in a dry place, moisture and rain
The correct use of the Excavator rock breaker can not only greatly improve the work efficiency, but also prolong the service life of the breaker. The best of both worlds, why not!
The repair and replacement cost of the hydraulic post knocker is relatively expensive. Interestin...
5, The excavator jackhammer is weak The breaker hammer is weak, and the hose on the site is shak...